Icon Matrice

Aluminum counter plates are used for higher volume and repetitive runs. They are much less likely to break and last much longer than conventional counter plates. They will easily cost justify the price difference. The ones in the picture above are made with a reverse crease. There are very few people in the industry that will supply them and Icon is one of them, though we also make the standard pertinax ones.

Dies

Our dies are made with only the highest quality materials. We have all the latest technology to help us make our dies the easiest for you to handle, not to mention a few of our own trade secrets. Through our research and development, we are constantly on the cutting edge of improving the manufacturing process of our dies.

Our female blankers are manufactured with the understanding of the press to where they are being run. All your layouts are carefully analyzed in order for us to evaluate the type of tool needed. The female shown above, for certain reasons, is made of 5/8" steel.

Grid

Above we have a grid blanker, male & female. This type of blanker is used for common cut jobs. If the separator bars in the female part are not strategically placed for the job, your die cutter will not be at optimum speed. Should your stock give you some problems our male blanker is made with certain adjustable features that will get you up and running quickly.

Our male and female stripping boards are manufactured with a lot of thought. First thing we'll do is assess what has to be stripped, always making sure we don't over strip for obvious reasons. We plan for a lot on our tools, even air flow and its affects on the speed of your run.

Our male blankers are manufactured with the understanding of the press to where they are being run. All of our male blankers are made with certain adjustable features to minimize press down time due to over nicking, humidity in the stock, or anything of that nature. We also sell with every job fully reusable pushers and bars. It would take approximately three minutes to remove two pushers and one bar from one male to the next. The pushers and bars currently have a patent pending.

At Icon we also specialize in brass sealing dies. The above picture is showing a permanent sealing die. It's made with an aluminum bottom plate and aluminum angles. All assembled together with one hundred percent accuracy. We know our quality in these types of tools is unsurpassed.

What you see above is a full set up for the product you see standing in the rear of the picture. The quality, workmanship and material used for this or any other of our tools is uncompromised.

What you see above is a full set of tooling. As you can tell just by the look of our tools they are made for maximum output, and minimum fuss on your part. All our tools come press ready, with all registration & alignment hole. We can supply any tools needed in our market today, from steel counter plates to dies made with Rayform. We have no doubt in our mind that you will be satisfied with our product.

We guarantee it!

We make all tools for our industry. Including the strip clip. We have made some strip clip tools that have run at maximum press speed without the use of 1 single bottom pin, which was very difficult until now. Not all layouts are suitable for this tool but it is very effective in saving time on the ones it is.

When we make a tool at Icon we try to make sure we understand the philosophy of the press it's going to run on. Roller dies are no exception. As you can see in the picture above our dies are made to do the job.

Puzzle Die

At Icon there is no die we cannot do. As you see even puzzles of all sizes weather 3-D or flat are done by us with ease and precision.

4145 Griffith
St.Laurent
QC
H4T 1A9
Tel:
(514) 344 3446
Fax:
(514) 344 4140
Toll Free:
1-866-ICON SRD
(1-866-426 6773)

Email:
pquercia@iconsrd.com